|
. |
|
| |
Why Splashtech? Because of Splashtech's quality of products, history, professionalism (all three of which have been discussed in About Splashtech) as well as its incredible variety! In this section, let's look at the total variety of products available from Splashtech:
|
|
| A. |
80 CM. TUBE (31½")
|
| 1. |
Splashwhip™ - describes a speed slide which descends in a straight direction at a 45-degree angle and then "whips" back 180 degrees to splash down into a runout. Average length is approximately 220 feet (including runout).
Recommended water usage: 150-200 gpm. |
| 2. |
Splashspiral™ -describes a speed
slide with a full 360 degree spiraling loop which splashes down in
either a pool or runout. Approximate length is 150 feet.
Recommended water usage: 200-250 gpm. |
| 3. |
Splashcliff™ - describes a very steep, giant
drop waterslide which empties into a runout, with a slope of up to
67 degrees. Approximate length is 200 feet (including runout).
Recommended water usage: 100-150 gpm. |
| 4. |
Splashtwist™ -
describes a double-helix waterslide which is recommended to come off
a 40 foot tower.
Total slide length is approximately 445 feet with a 40-foot runout.
Recommended water usage: 250-300 gpm. |
| 5. |
Splashshoot™ - describes a short speed slide
which "kicks" riders off at between 6 to 42 inches above water level
(utilizing a deep
pool).
Recommended water usage: 100-150 gpm. |
| 6. |
Splashtube Jr.™ -
describes a small diameter slide with approximately twice the slope
of our standard waterslide
(approximate slope is 15 degrees); this is not considered a speed
slide, but is a cost
effective alternative to using a larger diameter waterslide.
Approximate
length is 300 feet (not including runout, because a pool is normally
used).
Recommended water usage: 300-350 gpm. |
| 7. |
Splashdrop™ -describes a combination open/enclosed flume speed Slide, with a slope of up to 70 degrees, coming off a tower height of 40-60' and emptying into a run out of between 70-120' in length. Total slide length with run out is between 170-245'.
|
| B. | 4½ FT. DIAMETER TUBE
|
| 1. |
Splashtube™ - average slope is 7 degrees,
with average length off a 40' tower being 360'. Normal depth of splashdown
pool is 4½' of water (average pool size is 28' wide by 30' long).
Recommended water usage: 2,000 gpm from a 30 hp pump. |
| 2. |
Splashtube™ Black Hole - the same
requirements apply as in Number 1, above, except if used with two-
and three- person inner tubes or boats, the average slope is 5 degrees,
giving a Slide length of 390'.
|
| 3. |
Splashtube™ Triple Falls - has three distinct and progressive drops, emptying into a run out for added safety. Slide length off a 48' tower is 338' (which includes 108' of Slide run out), and this attraction is used with two and three- person inner tubes and boats (in correlation with Splashtech's special multiple-person loading system).
|
|
|
|
| A. | 42'' DIAMETER OPEN FLUME SLIDE
|
| 1. |
Splashdown™ - average slope, length and requirements are approximately the same as for the Splashtube™, above, with the exception that Splashtech's Stock Slides are pre-packaged designs for both open and closed flume Slides off tower heights starting at 6' above deck.
|
| B. | 72" AND 84" OPEN FLUME SLIDES
|
| 1. |
Splashrapids™ - 72'' Open Flume Slide with the same average slope, length and requirements as for the Splashtube™, above. |
| 2. |
Splashfalls™ - 84'' Open Flume Slide with same average slope and length as for the Splashtube™, above.
Recommended water usage: 3,000 gpm from a 45 hp pump.
|
| 3. |
Splashriver™ - 11.5' wide Open Flume Slide with three distinct drops for use with a 78'' four-person flat-bottom raft. Slide length is 230' for use with a splashdown pool which is 4½' deep and 35' by 35' in length and width.
Recommended water usage: 4,000 gpm from a 50 hp pump.
|
|
|
